HPE Community
ProLiant Servers (ML,DL,SL)
1754931 Members
1613 Online
108827 Solutions
New Discussion

ADIC Tape Device

 
Ayman Altounji
Valued Contributor

‎02-21-2001 04:00 PM

‎02-21-2001 04:00 PM

ADIC Tape Device

I've got an ADIC device that shows the SCSI ID for the ADIC on a reboot, but does not find the Quantum ID 3. This works on 2 other Proliant 2500 units. Is there anything I can check to correct this? The tape drive does not appear in NT Control Panel so I cannot properly configure it within ArcServe.
0 Kudos
Reply
1 REPLY 1
Ayman Altounji
Valued Contributor

‎03-26-2001 04:00 PM

‎03-26-2001 04:00 PM

Re: ADIC Tape Device

Try moving the tape drive to one of the other Servers to verify the tape drive is working , if so, make comparsions with the drives , drivers and software setup .
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.