HPE Community
ProLiant Servers (ML,DL,SL)
1755561 Members
4342 Online
108836 Solutions
New Discussion юеВ

COMPAQ DLT 4000 TAPE DRIVE

 
Ayman Altounji
Valued Contributor

тАО01-21-2001 04:00 PM

тАО01-21-2001 04:00 PM

COMPAQ DLT 4000 TAPE DRIVE

NT CANNOT DETECT MY DLT 4000 INTERNAL TAPE DRIVE. HARDWARE IS RECOGNIZED AT BOOT UP AND I HAVE THE CORRECT DRIVER BUT STILL IT IS NOT DETECTED.
ANY IDEAS?
0 Kudos
Reply
3 REPLIES 3
Ayman Altounji
Valued Contributor

тАО01-25-2001 04:00 PM

тАО01-25-2001 04:00 PM

Re: COMPAQ DLT 4000 TAPE DRIVE

Hey I have the exact same problem did you resolve it yet>
0 Kudos
Reply
Ayman Altounji
Valued Contributor

тАО01-25-2001 04:00 PM

тАО01-25-2001 04:00 PM

Re: COMPAQ DLT 4000 TAPE DRIVE

Yes, I completely removed the SCSI adaptec controller and reinstalled the Adaptec 2940uw driver and now the drive is recognized. I guess NT just did not see the Adaptec during the original install.

This Adaptec is an add-in controller and not part of the built in 2-channel array controller. Hope this helps!
0 Kudos
Reply
Ayman Altounji
Valued Contributor

тАО02-06-2001 04:00 PM

тАО02-06-2001 04:00 PM

Re: COMPAQ DLT 4000 TAPE DRIVE

What controller did you remove ?
What driver where you loading ?
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.