Creating array with CLI on Smart Array P410i

[trep]

Hi,

New drives were just added to the server and for some reason, i cannot create a new array using the GUI (there are no options to create arrays) and the CLI gives me error when I try to create the new array.

This is the configuration:

Smart Array P410i in Slot 0 <>

array A < SAS, Unused Space: 0MB>

logicaldrive 1 <136.7 GB, RAID 1, OK>

physicaldrive 1I:1:1
physicaldrive 1I:1:2

array B < SAS, Unused Space: 0MB>

logicaldrive 2 <279.4 GB, RAID 1, OK>

physicaldrive 1I:1:3
physicaldrive 1I:1:4

unassigned

physicaldrive 2I:1:5
physicaldrive 2I:1:6

When i try to send the following command:

controller slot=0 create type=ld drives=2I:1:5,2I:1:6 raid=1+0

I receive an error saying:

This operation is not supported with the current configuration. Use the "show" command on devices to show additional details about the configurations.

First time using CLI and it says that the type=ld is supported since it will create the array and the logical drive at the same time.

Help would be appreciated hehe

Best regards,

trep

[JL Martinez]

Try with "drives=allunasigned".

[JL Martinez]

Sorry, "drives=allunassigned". There was an "s" missing.

[trep]

Hi,

Thanks for the help, i'm getting the same error message however.

Regards,

trep

[trep]

Just wondering, maybe i cannot configure 1+0 since it's only 2 disks ?

[trep]

I wish i could edit my posts...

Tried with RAID1, still the same message.