HPE Community
ProLiant Servers (ML,DL,SL)
1825704 Members
3315 Online
109686 Solutions
New Discussion

Disk fail HPE Smart Array E208i-p SR Gen10

 
Skoud
Visitor

‎02-27-2023 02:53 PM - last edited on ‎03-01-2023 12:47 AM by

‎02-27-2023 02:53 PM - last edited on ‎03-01-2023 12:47 AM by

Disk fail HPE Smart Array E208i-p SR Gen10

Hi everyone

I have a Microserver GEN10+ which was working perfectly since december, the FS turned into RO mode and after a reboot, the RAID failed.

I bought two new SSD disks, deleted the RAID1 array and made a new one. It worked perfectly during about 1 to 2 hours but then one of the drives failed and 30min later, the second one failed too.

I re-created the array with the same disks, and I got exactly the same issue.

SMART tests are ok. I updated the e208i-p firmware, with no change, then tried to downgrade it (it's currently running in v5).

I have another RAID array which has no issue

Do you guys have any idea to fix this ?

0 Kudos
Reply
1 REPLY 1
TVVJ
HPE Pro

‎02-28-2023 10:29 AM

‎02-28-2023 10:29 AM

Re: Disk fail HPE Smart Array E208i-p SR Gen10

Hello, 

If there known working hard drive spares, install them to isolate between the hard drives and the connectors.

Regards,



I work at HPE
HPE Support Center offers support for your HPE services and products when and how you need it. Get started with HPE Support Center today.
[All opinions expressed here are mine, and not official statements on behalf of Hewlett Packard Enterprise]
Accept or Kudo
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.