DL380 Gen 10 - Windows Boot Manager Error

[tonysaunders]

We have a DL380 Gen 10. Windows Server 2016 was installed successfully, but with the incorrect RAID configuration. I asked that it be reset and that the OS be reinstalled with the correct RAID configuration.

Ever since the first installation, we have been getting this error message whenever we go through Intelligent Provisioning.

I have seen the YouTube videos on installing Windows Server on the DL380s, and have done this successfully many times before. Any suggestions on things I can try to resolve this error?

[Ihaqueit]

We have a DL380 Gen 10. Windows Server 2016 was installed successfully.

Before installation you already configured RAID

Incorrect RAID configuration.

How incorrect if once you setup the OS do not play with RAID, otherwise setting lost and Windows error.

Raid setup.

(320) HPE ProLiant DL380 Gen10 Configure RAID with iLO - YouTube

Server Installation.

(320) Install Windows Server 2016 Standard On HPE Proliant DL380 Gen10 - YouTube

[Cali]

Hi,

I assume there are still some Partition fragments on the Disks.

Try this:

Start Windows Setup from USB (Rufus), DVD, DVD over iLO
Shift + F10 für CLI
Type DISKPART
Type LIST DISK and identify the hard disk number (from 0 to n disks)
Type SELECT DISK <n> where <n> is the SSD disk number
Type CLEAN
Type EXIT twice (once to get out of DiskPart, the other to exit the command line tool)
Reboot the server and start the installation again.

Cali

[tonysaunders]

Thanks for this but as I mentioned in my post - I have seen these YouTube videos. All of these steps have been followed correctly. When the server reboots after installing through Intelligent Provisioning this is the error that I get.

[Ihaqueit]

What is boot mode?

[tonysaunders]

UEFI

[Ihaqueit]

Check this blog.

SOLVED - HP Proliant DL380 Gen 10 installing problem | TrueNAS Community

[ManBha]

Hello,

Please do try the below steps.

1. Restore system defaults

Procedure

1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration (RBSU) > SystemDefault Options > Restore Default System Settings.
2. Select Yes, restore the default settings.
3. Reboot the server

2. Perform an SPP update.

3. If the issue persists, please do perform a secure erase. [ please refer page: 50]

https://support.hpe.com/hpesc/public/docDisplay?docId=a00017037en_us&docLocale=en_US

Thanks.