HPE Community
ProLiant Servers (ML,DL,SL)
1850978 Members
2282 Online
104056 Solutions
New Discussion

Failed Processor

 
Ayman Altounji
Valued Contributor

‎05-08-2001 04:00 PM

‎05-08-2001 04:00 PM

Failed Processor

A week ago, one of the processors on my Proliant 3000 failed with the error message "212 Processor 2 failed". I have replaced the processor (PII 300 Mhz), the voltage regulator and the processor board and am still getting the same error messages. The only component I have yet to change is the system board, a task I am reluctant to perform unless absolutely necessary.

Any ideas????
0 Kudos
Reply
1 REPLY 1
Ayman Altounji
Valued Contributor

‎05-15-2001 04:00 PM

‎05-15-2001 04:00 PM

Re: Failed Processor

Run the Configuration manager at boot up (F10), it will ask you if the processor(s) is/are working again with a (yes/no) question. The Configuration manager remembers that at least on of the proccesors failed basically all you are doing is clearing that.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.