HPE Community
ProLiant Servers (ML,DL,SL)
1855501 Members
3409 Online
104111 Solutions
New Discussion

HP Proliant ML350 Gen10 disk problem after replacement

 
theuerv
Established Member

‎12-05-2023 06:17 AM - last edited on ‎12-07-2023 08:34 AM by

‎12-05-2023 06:17 AM - last edited on ‎12-07-2023 08:34 AM by

HP Proliant ML350 Gen10 disk problem after replacement

Hello,

I have a Proliant ML350 G10 with an HPE Smart Array P408i-a SR Gen10 controller. 3 drives in RAID5. One disk failed. I replaced it. In ILO, the volume status is now Enabled, but the replaced disk is now Enabled
(NonAuthenticDrive) Drive is HPE, same model, different firmware version. Installing Proliant SPP Gen10 might solve the problem.

0 Kudos
Reply
2 REPLIES 2
support_s
System Recommended

‎12-05-2023 07:19 AM

‎12-05-2023 07:19 AM

Query: HP Proliant ML350 Gen10 disk problem after replacement

System recommended content:

1. HPE ProLiant ML350 Gen10 Server - System Manageability

2. Compaq ProLiant ML350 Setup and Installation Guide

 

Please click on "Thumbs Up/Kudo" icon to give a "Kudo".

 

Thank you for being a HPE valuable community member.


Accept or Kudo

0 Kudos
Reply
TVVJ
HPE Pro

‎12-07-2023 08:13 AM

‎12-07-2023 08:13 AM

Re: HP Proliant ML350 Gen10 disk problem after replacement

Hello,

You may refer to advisory titled "HPE Multiple Server Platforms - Replacement Smart Carrier Backplanes May Come with Covers Over the Smart Carrier Pins, Resulting in Drives Not Being Detected or Reported as "NON-Authentic" Once Installed" and see if it helps.

Regards,



I work at HPE
HPE Support Center offers support for your HPE services and products when and how you need it. Get started with HPE Support Center today.
[All opinions expressed here are mine, and not official statements on behalf of Hewlett Packard Enterprise]
Accept or Kudo
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.