HPE ProLiant MicroServer Gen10 Plus RAID problem - Ubuntu Installation

[ParkerLau]

Hi All, 

I am facing the problem when i just received the server "HPE ProLiant MicroServer Gen10 Plus". I have tried to enable the RAID mode and created the RAID array. After that i try to install the Ubuntu Server 22.04.1 LTS, but it seem i unable to find the array. The page show two hard drive only during the installation. May i know some suggestion to install the ubuntu  22 to HPE ProLiant MicroServer Gen10 Plus server with RAID 1 configuration. Thank you.

Parker

[pchops]

---

---

The embedded Smart Array S100i is a "software" RAID controller and only supports Windows. See the quickspecs for additional details, ie:

https://www.hpe.com/psnow/doc/a00073554enw

Software RAID

• HPE Smart Array S100i SR Gen10 Software RAID

Notes:

− HPE Smart Array S100i SR Gen10 SW RAID will operate in UEFI mode only. For legacy support an additional controller will be needed

− The S100i only supports Windows. For Linux users, HPE offers a solution that uses in-distro open-source software to create a two-disk RAID 1 boot volume. For more information visit: https://downloads.linux.hpe.com/SDR/project/lsrrb/