iLO 4 - snmp not working

[Manuito]

Hello.
I have the following server ProLiant ML310e and I am trying to get server information though snmp protocol to monitorize it.

Those are the SNMP settings

But I only get a few parameters.

root@zabbix:~# snmpwalk -v1 -c public 172.23.39.254
SNMPv2-MIB::sysDescr.0 = STRING: Integrated Lights-Out 4 2.30 Aug 19 2015
SNMPv2-MIB::sysObjectID.0 = OID: SNMPv2-SMI::enterprises.232.9.4.10
DISMAN-EVENT-MIB::sysUpTimeInstance = Timeticks: (3973156791) 459 days, 20:32:47.91
SNMPv2-MIB::sysContact.0 = STRING: Manu & Chisco
SNMPv2-MIB::sysName.0 = STRING: servidor.santaeulalia
SNMPv2-MIB::sysLocation.0 = STRING: IES Santa Eulalia
I don't see others like temperatures, power supplies, etc.

Thanks in advance

[Manuito]

After upgrade iLO version to 2.61 Jul 27 2018, the result is the same.

root@zabbix:~# snmpwalk -v2c -c public 172.23.39.254
SNMPv2-MIB::sysDescr.0 = STRING: Integrated Lights-Out 4 2.61 Jul 27 2018
SNMPv2-MIB::sysObjectID.0 = OID: SNMPv2-SMI::enterprises.232.9.4.10
DISMAN-EVENT-MIB::sysUpTimeInstance = Timeticks: (56453) 0:09:24.53
SNMPv2-MIB::sysContact.0 = STRING: Manu & Chisco
SNMPv2-MIB::sysName.0 = STRING: servidor.santaeulalia
SNMPv2-MIB::sysLocation.0 = STRING: IES Santa Eulalia

[KK]

Hi Manuito,

To get the response temperature, PSU, etc., one need to provide the OID.

To get the OID for the MIB kit is available at https://support.hpe.com/hpsc/doc/public/display?docId=emr_na-c04272529.

The MIBs are self explanatory and can be read in an editor and extract the required OID from MIB kit.

The syntax would be #snmpwalk -v1 -c public iLO4IP/FQDN OIDstring

You can refer the blog https://ixnfo.com/en/snmp-oid-list-for-ilo4.html for iLO4 SNMP OID list.

Disclaimer: One or more of the links above will take you outside the Hewlett-Packard Enterprise web site, HPE does not control and is not responsible for information outside of the HPE web site.

"If you feel this was helpful please click the KUDOS! Thumbs below!"

Regards,
KK

[Manuito]

Theoretically, writing "snmpwalk -v1 -c public IP" must show all available data. MIBS, OID and OIDstring aren't necessaries.

[Manuito · Accepted solution]

with snmpwalk -v1 -c public IP .1.3.6.1.4.1.232  it shows everything.

Thanks :)

[KK]

Yes, it is right.

Also, please check usage when we run the SNMPWALK, it provides the usage as below: