HPE Community
ProLiant Servers (ML,DL,SL)
1833159 Members
3222 Online
110051 Solutions
New Discussion

Re: Installing NT4.0 without smartstart CD

 
Ayman Altounji
Valued Contributor

‎02-01-2001 04:00 PM

‎02-01-2001 04:00 PM

Installing NT4.0 without smartstart CD

Is it possible to Install NT4.0 without smart start CD with running into a blue screen --INACCESSIBLE_BOOT_DEVICE--

thx!
0 Kudos
Reply
1 REPLY 1
Ayman Altounji
Valued Contributor

‎02-13-2001 04:00 PM

‎02-13-2001 04:00 PM

Re: Installing NT4.0 without smartstart CD

In order to install NT on a system with a current Compaq SCSI controller, you need to create the 3 NT install disks from the NT CD. Use the "WINNT /OX" command to do this. Then, when the Smartstart manual install is done, boot from those disks - without the NT CD in the drive until asked. Choose "custom" for the install mode (F6 key) and skip detection on mass storage. Specify an unlisted controller and use the Compaq NT 4.0 SSD for the drivers. Then specify a secondary controller and use the NT "IDE/Atapi" driver. You can also use the SSD for the NIC drivers (also likely to be out of date in NT).
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.