HPE Community
ProLiant Servers (ML,DL,SL)
1823165 Members
3625 Online
109647 Solutions
New Discussion

ML30 Gen10 with Raidctrl S100i and Installation CentOS 7.x 1810

 
werner.zeller
Advisor

‎11-15-2019 06:02 AM

‎11-15-2019 06:02 AM

ML30 Gen10 with Raidctrl S100i and Installation CentOS 7.x 1810

Hi, I have a ML30 with the S100i arraycontroller with 2 Disks (1TB) for Raid1. I did create the Raid1 with the Array Controller software in the provisioning menu. After booting with of CentOS7x from USB, under Device Selection I can see both Disks, not the logical Lun.  What I need is Raid1 Hardware or Software based...

How can I do this?

 

Thnaks

 

Best regards

werner

 

0 Kudos
Reply
1 REPLY 1
Jimmy Vance
HPE Pro

‎11-15-2019 06:35 AM

‎11-15-2019 06:35 AM

Re: ML30 Gen10 with Raidctrl S100i and Installation CentOS 7.x 1810

@werner.zeller wrote:

Hi, I have a ML30 with the S100i arraycontroller with 2 Disks (1TB) for Raid1. I did create the Raid1 with the Array Controller software in the provisioning menu. After booting with of CentOS7x from USB, under Device Selection I can see both Disks, not the logical Lun.  What I need is Raid1 Hardware or Software based...

How can I do this?

 

Thnaks

 

Best regards

werner

 

The S100i Dynamic Smart Array is a software based RAID controller.  The software RAID function is only supported in Windows. For hardware based RAID you will need to install either the HPE Smart Array P408i-p SR Gen10 or the HPE Smart Array E208i-p SR Gen10 PCIe controller

No support by private messages. Please ask the forum! 
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.