ML310 G5 AND SMART ARRAY P410 PROBLEM.

[micmax]

FOUND PROBLEM!

The problem is a USB cable connect to UPS, i've disconnect this and ML310 G5 boot normally now! When i connect USB cable the boot process have problem, P410 don't start or BIOS don't recognize correctly a controller !!!

[Jimmy Vance]

Try changing the standard boot order in RBSU and move USB after the hard disk

[micmax]

No, i think is a BIOS of server or firmware of P410 controller problem, because when on boot the P410 are not recognized, i have to remove P410 controller, power on server without it then power off, install P410 controller then power on, and server boot correctly with P410 recognized!!!

probably BIOS rebuild a PCI IRQ assignement !!!

[micmax]

FINALLY SOLUTION:

hardware replacement need on P410 SA! 

Now DS1 led check error always server start!

Same problem in this post:

http://h30499.www3.hp.com/t5/ProLiant-Servers-Netservers/P410-controller-problem/td-p/6159039#.U0pr33mKCM8