Problema com Rota em iLo 4 com Vlan - Problem with Route in iLo 4 with Vlan

[PabloMichelin]

Tenho um servidor ML30 G9. Estou utilizando a iLo dele em vlan porta compartilhada. Acontece que nao consigo fazer nenhum direcionamento externo  para o servidor. O Firewall nao encontra ele na rede. Meu firewall esta ligado diretamente na mesma porta em que esta a iLo compartilhada. Ele repassa todas as vlans para porta 1 do switch Hpe 1920. Configurei o IP da iLo manualmente. Eu consigo acessar iLo via rede interna de qualquer computador normalmente, porem o Firewall nao encontra a iLo na rede, sendo assim nao consigo fazer nenhum direcionamento externo. Na tabela app tambem nao esta sendo encontrado nenhum mapeamento. Na mesma situação tenho outro servidor ml30 G10 com iLo em porta compartilhada, em outra porta do switch, e funciona tudo perfeitamente. Alguém poderia me dar uma luz sobre essa situação?

I have an ML30 G9 server. I'm using his iLo on a shared port vlan. It turns out that I can't do any external routing to the server. The Firewall does not find it on the network. My firewall is connected directly to the same port as the shared iLo. It forwards all vlans to port 1 of the Hpe 1920 switch. I configured the iLo IP manually. I can access iLo via the internal network of any computer normally, however the Firewall does not find iLo on the network, so I cannot do any external routing. No mapping is also found in the app table. In the same situation, I have another ml30 G10 server with iLo on a shared port, on another switch port, and everything works perfectly. Could anyone shed some light on this situation?

[shiva_jr]

Hi @PabloMichelin ,
    I assume that ILO shared port is working fine. Please check with network settings such as Preferred and Alternative DNS, Gateway, Subnet settings are proper. You can compare with the working server, configure it in another server and validate.

Regards,
Shiva_JR
Please mark as 'Accepted solution' and give me 'Kudos' if my post worked.

[PabloMichelin]

thanks shiva_jr, same config with other server working

[Mr_Techie]

---

@PabloMichelin wrote:

thanks shiva_jr, same config with other server working

---

Then there may be a specific issue with the G9 server itself.

Firstly check any hardware issues. Like network interface card (NIC) on the ML30 G9 server is functioning properly or any physical issues with the NIC or the server's network connectivity components.

Try resetting the iLO interface. 

I hope this helps!. Let me know