HPE Community
ProLiant Servers (ML,DL,SL)
1826963 Members
4373 Online
109705 Solutions
New Discussion

Proliant ML110 G3 server

 
Koury Nelson
Occasional Contributor

‎10-13-2006 06:41 AM

‎10-13-2006 06:41 AM

Proliant ML110 G3 server

Have two hard drives and I swapped them over to RAID in the bios but now when the server boots up I get an error telling me to remove a hard drive and run CHKDSK /F to make sure hard drive is not corrupt. Server 2000 has already been installed on the primary hard drive. Any suggestions?
0 Kudos
Reply
1 REPLY 1
sandeep_raman
Honored Contributor

‎10-14-2006 05:03 AM

‎10-14-2006 05:03 AM

Re: Proliant ML110 G3 server

Hello Koury,

Its bound to crash or throw errors if you change the option in BIOS to Raid after OS is installed.

1.Does the server load OS?
2.Have you tried to revert to old settings,does it make any difference?
3.Whats the controller to which the disks are connected?

SRH
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.