HPE Community
ProLiant Servers (ML,DL,SL)
1851546 Members
4098 Online
104060 Solutions
New Discussion

Question to Raid Controller

 
SOLVED
Go to solution
Christian Bieletzki
Frequent Advisor

‎02-13-2005 08:06 AM

‎02-13-2005 08:06 AM

Question to Raid Controller

I have an "ML 570 R01" with a broken Raid controller. Is there a way to replace the controller and get the NVRAM configuration in order to maintain the DISK configuration for the raid array? I remember that it was possible on HP LH3000 servers to restore the NVRAM configuration from the disks.

Kind regards
Christian
Bille
0 Kudos
Reply
1 REPLY 1
Oleg Koroz
Honored Contributor

‎02-13-2005 01:00 PM

‎02-13-2005 01:00 PM

Solution

Re: Question to Raid Controller

If you lost only controller, you should fine and boot normally after replacement. If you cleared NVRAM you need:
http://h18007.www1.hp.com/support/files/server/us/download/13227.html Create first two diskettes only
verify firmware for array Controller also
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.