HPE Community
ProLiant Servers (ML,DL,SL)
1829624 Members
1942 Online
109992 Solutions
New Discussion

RAID configuration and system board replace

 
Mahbubul Hasan
Occasional Contributor

‎03-21-2009 12:27 AM

‎03-21-2009 12:27 AM

RAID configuration and system board replace

One of our Server which built-in RAID controller and RAID configuration is
RAID 1 for OS and RAID 5 for Data.
Unfortunately system board become faulty, that’s why we need to replace
the system board.
I need to know after replacing the system board, RAID configuration is working as before?

--
Md.Mahbubur Rahman


0 Kudos
Reply
2 REPLIES 2
JKytsi
Honored Contributor

‎03-21-2009 06:49 AM

‎03-21-2009 06:49 AM

Re: RAID configuration and system board replace

raid config is in the disks, so just put them back as they were with original.
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
0 Kudos
Reply
WFHC-WI
Honored Contributor

‎03-23-2009 01:42 PM

‎03-23-2009 01:42 PM

Re: RAID configuration and system board replace

Pay special attention to any message you get on the initial scan for disks at startup. You may see something to the effect of "Drive positions changed" or another message requiring you to choose F1 or F2. From what I can remember there is a fairly short timeout on this message so it may be best to press any key and carefully read the prompt.

Good luck!
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.