Raid Drive not showing during windows server installation

[ALI22222]

I have a DL180 G6, configured with RAID 0. During the installation of Windows Server 2012 R2, the RAID drive is not being detected. Any idea how to fix that, please?

[shiva_jr]

Hi ALI22222,

     May be the logical drive is not set as bootable. Please refer the below image set the required drive by the option "Select boot volume".

Second case is, sometimes if the disk had previously installed Linux OS then drive may be has GPT partition, please format the drive and start windows OS installation.
Regards,
Shiva_JR
Please mark as 'Accepted solution' if my post worked

[ALI22222]

Hello @shiva_jr ,

the below option  "select boot volume " is not avaialble in my same screen as yours  , please advise.

[Mr_Techie]

@ALI22222 

Double-check that the RAID array is properly configured in the RAID controller utility or BIOS settings. The RAID volume should be set up correctly before attempting to install the operating system.

I hope this helps. Let me know.