HPE Community
ProLiant Servers (ML,DL,SL)
1834926 Members
2575 Online
110071 Solutions
New Discussion

Remote system configuration?

 
Ayman Altounji
Valued Contributor

‎05-12-2002 04:00 PM

‎05-12-2002 04:00 PM

Remote system configuration?

We have about 100 servers that have been rolled out with the 'Halt at F1' option enabled in the system configuration. Is there any way of changing this parameter remotely?

The SmartStart scripting kit contains a util that will configure the BIOS, but it has to run from DOS. Could we somehow use this util?

Sorry, no RIBLOE boards installed!

Thanks
Mark
0 Kudos
Reply
1 REPLY 1
Ayman Altounji
Valued Contributor

‎05-21-2002 04:00 PM

‎05-21-2002 04:00 PM

Re: Remote system configuration?

Just wanted to let you know, that if such a utility exists, i would be happy to use it too.. So far I'm using the dos-version conrep which requires a DOS 6.20 or later Boot Diskette to work but works fantastic with the Virtual Floppy.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.