HPE Community
ProLiant Servers (ML,DL,SL)
1844968 Members
2131 Online
110233 Solutions
New Discussion

Tecram SCSI controller

 
Ayman Altounji
Valued Contributor

‎08-26-2001 04:00 PM

‎08-26-2001 04:00 PM

Tecram SCSI controller

1. Installed Tekram Controller to any PCI slots NT crash.
2. Disabled Tekram Controller in system utilities NT works.
3. Load Tekram controller driver in NT no problem encountered, but services will not start. (scsi controller still disabled in system utilities)
4. Enabled Tekram controller in system utilities NT works, scsi controller was detected in both DOS and in NT, services started but problem in NIC card will occur, conflict in I/O port address will appear in the event viewer.

pls help
0 Kudos
Reply
1 REPLY 1
Sunil Jerath
Honored Contributor

‎07-24-2002 04:00 PM

‎07-24-2002 04:00 PM

Re: Tecram SCSI controller

Hello,
You may need to lock the resources on the system board. But please contact the manufacturer of the third party hw for this issue.
Regards,
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.