This drive has FAILED and should be replaced.

[Florian Dushniku]

Hi,
HP Insight Diagnostic gives me this error (attached) when I do a Diagnose. I have to mention that the server is functioning normally and the lights are green. This is a ProLiant DL360 G4p. I am attaching the ADU report too.
I have the same problem in another server that I have posted in another thread. Regarding this other server I have done all the updates as suggested but the same situation continues.

[Johan Guldmyr]

Hi,

so why haven't you updated firmware on controller this controller?
Is 7.70 the latest ADU for this server?
Is the PSP or insight diagnostics not updated either?
Disk drive firmware looks like it's already the latest.

http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareIndex.jsp?lang=en&cc=us&prodNameId=466291&prodTypeId=329290&prodSeriesId=466290&swLang=8&taskId=135&swEnvOID=1005#29214

[Florian Dushniku]

The point is that even I did the update in the first thread the problem wasn't resolved.

[Johan Guldmyr]

In the previous thread ( http://h30499.www3.hp.com/t5/ProLiant-Servers-ML-DL-SL/HP-Insight-Diagnostics-reports-quot-This-drive-has-FAILED-and/m-p/5282044#M123045 )

the controller is not the same.

[Florian Dushniku]

yes I know, nut I am afraid that the same situation will happen even after the update if I do it. What should I do?

[Johan Guldmyr · Accepted solution]

On this disk:

Port 2I, Box 1, Bay 3

(since factory, the two other are 0)
Hrd Read 00000008

So there have been hard read errors, but not lately.

Again, if the tool says that the disk should be replaced ... why not replace it?

[Florian Dushniku]

Ok. There is not any problem to replace it, but why does it say FAILED while the HDD is working normally and the light is green. Does it mean that the HDD has high possibilities ti fail completely? What procedure is followed to replace a HDD in RAID 1+0?

[Johan Guldmyr]

To find out why the program is saying failed while (as far as we can tell the drive looks OK), I suspect you would need to ask for some assistance by HP - best way to do that would be through the support.

To replace a drive in a smart array controller with RAID1+0 and 4 drives you just take out the old one and put in a new one. Then rebuild will start.

[Florian Dushniku]

I should take it out while the server is working or I should shut it down? To be safer is there any problem to shut it down first, then replace it, then start the server? will the rebuild start in this way?
what about in RAID 1+0 with 2 HDD. can i follow the same procedure?

[Johan Guldmyr]

You can find the official instructions in the user guide for each controller.

Here is the one for p600:

http://bizsupport.austin.hp.com/bc/docs/support/SupportManual/c00440340/c00440340.pdf

See page 22 for differences between doing it online and offline.

[Florian Dushniku]

ok thank you.

[Florian Dushniku]

I think I will replace the HDD in the next days.