HPE Community
ProLiant Servers - Netservers
1819817 Members
3409 Online
109607 Solutions
New Discussion

DL380G5 - can I get the hard disk light to blink to identify a drive?

 
SOLVED
Go to solution
Old-Timer
Occasional Contributor

‎04-24-2009 09:26 PM

‎04-24-2009 09:26 PM

DL380G5 - can I get the hard disk light to blink to identify a drive?

First HP server. I'm used to Dell and IBM servers. They have utilities to blink one of the LEDs on a drive to identify it.

I can't seem to figure out how to do this on a DL380G5. I have 6 x SAS hot-swap drives.
0 Kudos
Reply
1 REPLY 1
Dave.
Valued Contributor

‎04-27-2009 02:01 AM

‎04-27-2009 02:01 AM

Solution

Re: DL380G5 - can I get the hard disk light to blink to identify a drive?

One way is to use the Array Configuration Utility (assuming you are running windows and have the ProLiant Support Pack installed). Open this up (from Start; Programs;HP System Tools; HP ACU; HP ACU; run locally), selecting the array should make all disks in the array flash. Changing the view (in ACU) to physical will let you select the individual disk and then only that will flash.
Hope that helps, let me know if not clear enough.
Dave
Regards, Dave
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.