HPE Community
ProLiant Servers - Netservers
1848592 Members
5571 Online
104033 Solutions
New Discussion

ML110 G5 and RAID1: How to tell when a hdd fails?

 
Guillermo Avalos
Occasional Advisor

‎05-11-2009 04:11 PM

‎05-11-2009 04:11 PM

ML110 G5 and RAID1: How to tell when a hdd fails?

I've a ML110 G5 set up with two HDDs in RAID1 on the built-in SATA RAID controller. In the event of a hdd failure, how would I be notified? I don't have any application for RAID management installed (Windows Server 2003). How would I know which hdd has failed?
0 Kudos
Reply
2 REPLIES 2
Lord Pit
Frequent Advisor

‎05-12-2009 02:03 AM

‎05-12-2009 02:03 AM

Re: ML110 G5 and RAID1: How to tell when a hdd fails?

Check in the ARRAY CARD BIOS/ROM, you will have all info there.

PS. if the RAID 1 is damaged the beeper should beep ;)
When you are giving points It's like saying Thank You :-)
0 Kudos
Reply
jbainbridge
Advisor

‎05-18-2009 12:31 AM

‎05-18-2009 12:31 AM

Re: ML110 G5 and RAID1: How to tell when a hdd fails?

I've got 2 setup. Go to the support / drivers page and install the management software / service. It can be set to send you an email when faults arise.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.