HPE GreenLake Administration
- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers - Netservers
- >
- Netserver LH3 raid array recovery
ProLiant Servers - Netservers
1833882
Members
2299
Online
110063
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Forums
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-08-2002 06:21 AM
06-08-2002 06:21 AM
Netserver LH3 raid array recovery
We have lost our nvram configuration and raid disk configuration on our Netserver LH3 (PII 450mhz). Server boots up with no NOS detected. Is there any way we can have the server recover without reinstall NOS? Should I run the consistency check? Any help will be appreciate.
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-09-2002 10:24 PM
06-09-2002 10:24 PM
Re: Netserver LH3 raid array recovery
Hello Kenny,
A possible solution is to reconfigure the array controller exactly as it had been configured in the past. After configuration, do not initialize and attempt to boot off the configured logical disk.
Alternatively, if you don't have the NetRAID configuration parameters, you could opt to reconfigure the array to your liking, reinstall a basic version of the OS and do a restore...
I hope this helps.
Erwin
A possible solution is to reconfigure the array controller exactly as it had been configured in the past. After configuration, do not initialize and attempt to boot off the configured logical disk.
Alternatively, if you don't have the NetRAID configuration parameters, you could opt to reconfigure the array to your liking, reinstall a basic version of the OS and do a restore...
I hope this helps.
Erwin
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
Company
Events and news
Customer resources
© Copyright 2025 Hewlett Packard Enterprise Development LP