HPE Community
ProLiant Servers - Netservers
1849745 Members
8859 Online
104044 Solutions
New Discussion

Re: Replacing failed disk in RAID array

 
BR147023
New Member

‎10-30-2002 04:29 PM

‎10-30-2002 04:29 PM

Replacing failed disk in RAID array

What is the correct proceedure for replacing a 18GB disk in an LH3000, if the customer insists on powering down the server before the disk is swapped.

There are 3 x 18GB disk setup with Raid 5.

I have tried swapping the failed disk, with the server powered off, but on power up the new disk remains in the failed red state.
0 Kudos
Reply
1 REPLY 1
CA739512
Frequent Advisor

‎10-31-2002 05:47 AM

‎10-31-2002 05:47 AM

Re: Replacing failed disk in RAID array

If you power the server down to replace a failed hdd then auto-rebuild will not kick off. Boot into Ctrl-M and start a manual rebuild there. You'll have a rebuild option on the main menu.

Ciao,
Greg
Lets Roll!
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.