HPE Community
HPE Aruba Networking & ProVision-based
1830763 Members
2136 Online
110015 Solutions
New Discussion

Who Me Too'd this topic

Eric Nyman
New Member

‎11-23-2005 03:39 AM

‎11-23-2005 03:39 AM

Procurve 2650 - show arp

When I execute a show arp command, the only ip address that is displayed is the gateway address.

IP Address MAC Address Type Port
--------------- ------------- -----
10.90.24.1 0009b6-5ffg45 dynamic 49

If I physically ping a known ip address of a device that is connected to the switch (as an example, I will ping 10.90.24.236 which is a server that is on port 4), then that address will then appear after the show arp command is executed.

IP Address MAC Address Type Port
--------------- ----------------- -----
10.90.24.1 0009b6-5ffg45 dynamic 49
10.90.24.236 000d56-16c7r6 dynamic 4

Is there something I should do to make the ip/arp translate automatic without having to ping the address.

The configuration on this switch is basic with only two vlans.
1 person had this problem.
0 Kudos
Who Me Too'd this topic
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.