- Community Home
- >
- Storage
- >
- Entry Storage Systems
- >
- Disk Enclosures
- >
- Who Me Too'd this topic
Disk Enclosures
1754358
Members
4811
Online
108813
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Who Me Too'd this topic
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-02-2009 07:02 AM
07-02-2009 07:02 AM
MSA 1000 failed HDD replaced, rebuild not starting
I know this has been asked before with similar configs, but I've not see this specific to my hardware:
Upon startup, bay #12 in one of my MSA1000's lit red. I've hot replaced the failed drive. MSA1000 sees the drive hot added, and Array Configuration Utility v7.50.23.0 (Windows) now shows the new HDD as unassigned. Nowhere can I find a place to assign the drive, and begin the rebuild process. I thought it starts automatically, but it's been quite a while since I've been through the scenario.
How do I nudge the MSA1000 to rebuild the array back to RAID using the replaced drive?
I plan to restar the MSA1000 and attached server in a few hours, I hope that does the trick.
Upon startup, bay #12 in one of my MSA1000's lit red. I've hot replaced the failed drive. MSA1000 sees the drive hot added, and Array Configuration Utility v7.50.23.0 (Windows) now shows the new HDD as unassigned. Nowhere can I find a place to assign the drive, and begin the rebuild process. I thought it starts automatically, but it's been quite a while since I've been through the scenario.
How do I nudge the MSA1000 to rebuild the array back to RAID using the replaced drive?
I plan to restar the MSA1000 and attached server in a few hours, I hope that does the trick.
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP