HPE Community
HPE Aruba Networking & ProVision-based
1830768 Members
2114 Online
110015 Solutions
New Discussion

Who Me Too'd this topic

mbjoe
Occasional Contributor

‎12-10-2011 04:03 PM - last edited on ‎03-17-2014 02:36 AM by

‎12-10-2011 04:03 PM - last edited on ‎03-17-2014 02:36 AM by

Cannot Ping Subnets on HP Procurve 2510/v1910

We are trying to setup three new switches and are having some difficulties when it comes to our overall WAN setup.

 

The switches function fine for the branch they are setup for but when trying to access or even ping the switches over the WAN from a different subnet we get no response.

 

The Procurve 2510 does not seem to have any routing capabilities so that's the one I'm most concerened about. Is there a setting or something I'm missing that would enable other subnets on the network to simply ping the switch? When it comes to the v1910s, I think I have that fixed by creaing a static route for 0.0.0.0 to the Default Gateway in that branch, would that be correct?

 

Can anyone offer some insight?

 

 

P.S. This thread has been moevd from Switches, Hubs, Modems (Legacy ITRC forum) to ProCurve / ProVision-Based. - Hp Forum Moderator

1 person had this problem.
0 Kudos
Who Me Too'd this topic
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.