HPE Community
ProLiant Servers (ML,DL,SL)
1820060 Members
3037 Online
109608 Solutions
New Discussion

Who Me Too'd this topic

KSS534
Occasional Contributor

‎05-24-2023 08:25 PM

‎05-24-2023 08:25 PM

DL380 Gen10 : After enabling Memory remapping option, cannot boot

Hi Team

We had an issue where in one of the DIMM was shown as "Mapped out,error". We rebooted and pressed F9.

Now we followed the following steps . After saving and exiting the BIOS page, the node isnt booting. Cannot enter BIOS also!!!

Configuring memory remapping

 

Use the Memory Remap option to remap system memory that might be disabled due to a failure event, such as an uncorrectable memory error.

Procedure
  1. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration (RBSU) > Memory Options > Memory Remap.
  2. Select a setting.

    • Remap All Memory—Makes all memory in the system available again on the next boot.

    • No Action—Leaves any affected memory unavailable to the system.

  3. Save your setting.

 

 

 

Attaching the screenshot of error seen during boot. 

1 person had this problem.
0 Kudos
Reply
Who Me Too'd this topic
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.