HPE Community
HPE OneView
1827088 Members
2612 Online
109713 Solutions
New Discussion

Who Me Too'd this topic

MartC
Senior Member

‎02-07-2025 03:47 AM - last edited on ‎02-20-2025 12:53 AM by

‎02-07-2025 03:47 AM - last edited on ‎02-20-2025 12:53 AM by

How to pull uplink port digital diagnostic rx/tx dbm values

We had an issue recently where we had to replace a couple of SPF modules within our Virtual Connect SE 16Gb FC Module for Synergy modules

This can be discovered within OneView Rx Power (dBm) and Tx Power (dBm) values are below or over a certain threshold

I am trying to pull these values from OneView using the OneView PowerShell module

I can get as far as listing the relevant 16 or 32 Gb IC modules and relevant data within but am unable to obtain the additional Digital Diagnostic data

We have several Synergy FrameSets and would like to be able to pull these values accross our estate

Any assistance would be greatly appreciated as I am stumped

Thanks

1 person had this problem.
0 Kudos
Reply
Who Me Too'd this topic
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.