HPE Community
Server Management (Insight Manager 7)
1833289 Members
3251 Online
110051 Solutions
New Discussion

Re: Invalid VxD dynamic link call....

 
Ayman Altounji
Valued Contributor

‎01-16-2001 04:00 PM

‎01-16-2001 04:00 PM

Invalid VxD dynamic link call....

When I'm booting a Proliant ML530 server on v4.8 of SmartStart, I get the following message:
"Invalid VxD dynamic link call to device no.3, service B"

The system then halts. Same also occurs with v4.6 - any ideas?
0 Kudos
2 REPLIES 2
Ayman Altounji
Valued Contributor

‎01-16-2001 04:00 PM

‎01-16-2001 04:00 PM

Re: Invalid VxD dynamic link call....

Put the server in the 'out of the box' condition for the install to see if the error goes away.
0 Kudos
Ayman Altounji
Valued Contributor

‎01-17-2001 04:00 PM

‎01-17-2001 04:00 PM

Re: Invalid VxD dynamic link call....

Thanks for the reply. After running a diagnostic on the server I have a memory parity error - the offending chip has been replaced and everything is working fine.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.