- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- Server Management - Systems Insight Manager
- >
- Imported MIB not appearing
Server Management - Systems Insight Manager
1752577
Members
5372
Online
108788
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-22-2009 05:52 AM
10-22-2009 05:52 AM
Imported MIB not appearing
HP SIM 5.3 with Update 1 on Linux - clean install.
I successfully compiled and imported several MIBs. A trap sent appears as a recognized event, listing the correct MIB under the Trap Details section for the event.
The problem is that the defined severity needed to be adjusted. Unfortunately, when I go to Options, Events, SNMP Trap Settings, the MIB is not listed at all.
I can delete the MIB, no error, readd the MIB, no error, but it still does not show up.
I have also compiled and imported a few other MIBs and they show up fine.
I have uninstalled and reinstalled SIM, no luck.
Any ideas? Thanks.
I successfully compiled and imported several MIBs. A trap sent appears as a recognized event, listing the correct MIB under the Trap Details section for the event.
The problem is that the defined severity needed to be adjusted. Unfortunately, when I go to Options, Events, SNMP Trap Settings, the MIB is not listed at all.
I can delete the MIB, no error, readd the MIB, no error, but it still does not show up.
I have also compiled and imported a few other MIBs and they show up fine.
I have uninstalled and reinstalled SIM, no luck.
Any ideas? Thanks.
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP