HPE Community
Server Management - Systems Insight Manager
1833077 Members
3062 Online
110049 Solutions
New Discussion

power redundancy monitoring

 
Dean Emberton
Occasional Advisor

‎07-19-2004 07:11 AM

‎07-19-2004 07:11 AM

power redundancy monitoring

I have a DL760 with dual PS that is running right at 50% utilization. Depending on load it will increase to over 50% and I then get paged. How can I setup monitoring to monitor the failure of the PS's without monitoring that redundancy state?

I hope this makes sense.

Thanks
Dean
0 Kudos
Reply
1 REPLY 1
David Claypool
Honored Contributor

‎07-19-2004 07:49 AM

‎07-19-2004 07:49 AM

Re: power redundancy monitoring

Change your Automatic Even Notification task to use the rule:

where [event category] name [is] [ProLiant System and Environmental Events] and type name is [Power Supply Failed (ver. 4)]
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.