- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- Server Management - Systems Insight Manager
- >
- Re: Send HP SIM alerts at an interval?
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Forums
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-01-2012 10:01 AM
08-01-2012 10:01 AM
Hi there,
I am using HP SIM6.3 to monitor some remote servers. From time to time, there may be some network glitches that the servers may lose connection to the HP SIM. In other words, HP SIM may see them "dead" so alerts will be triggered. Is there a way I can configure it not to trigger any alert in a given time period? Say, wait for 5 minutes, if it is still not able to PING them, then trigger the alerts?
Much appreciated,
Ehuang
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-01-2012 01:29 PM
08-01-2012 01:29 PM
SolutionKind of .... :)
You can change the global ping settings under Options -> Protocol Settings -> Global Protocol Settings but that will apply to all systems. If you wish you can set ping timeouts and retry intervals on a per system basis also in the system protocol settings for that system. What I'm gathering though is that you want to dynamically set these setting during specific time periods?