Smart Update Manager takes for ever doing inventory

[quesnl]

Does anybody else have the issue sometime when adding a baseline in Smart Update Manager it takes for ever doing the "Inventory in progress" phase ? 

Is there a fix to speed up that phase or something I can do ? 

[shiva_jr]

Hi quesnl,
      There may be multiple root cause for delay in completing the inventory. Please follow these causes and get it resolved. Please refer this document for more info.

Cause 1: SUM might not have system or network resources
Action: Do not deploy more than the 50 nodes at a time, or 10 VMware nodes at a time

Cause 2: Performing inventory on more than one baseline might use too many system resources
Action: Perform inventory on one SPP baseline at a time

Cause 3: SUM does not show any dependency and fails to install because SUM 8.1 does not support iLO downgrade
Action: Perform the downgrade outside of SUM. Extract iLO Smart Component to a directory and then uploadthe firmware binary file directly using the iLO interface.

Regards,
Shiva_JR
Please mark as 'Accepted solution' if my post worked.

[quesnl · Accepted solution]

I finaly did a clean-cache and it fix the issue. I tought I could get away without doing a clean-cache since clear evrything and you have to start evyrhting from scratch EI: adding the nodes and the baseline.

[Sunitha_Mod]

Hello @quesnl,

We are glad to know you were able to find the solution and we appreciate you for keeping us posted.