HPE ESL G3 Tape Library LMC Issue

[HP1133]

Hi

I'm working with a HPE ESL G3 Tape Library. My Drives are ok software status and LED wise.

I tried to power cycle them via the LMC. However it shows an error message of "failed to power cycle". Similarly it shows the same error while varying off, hard and soft reset. 

Can any one please guide how to resolve this issue as the drives are other wise performing normally.

[NarayanKK-SO]

@HP1133

Did you try to power down the device completely and pull out the power cable. Wait for 5mins. Connect cable again and test ?. If this has been tried then the LMC is not communicating as expected and needs replacement.

If not, please try and share the outcome.

Hope this helps.

[NarayanKK-SO]

@HP1133

Do let us know the current system state post power cycle. 

Thanks.