Switches, Hubs, and Modems
1748132 Members
3452 Online
108758 Solutions
New Discussion юеВ

Re: Cannot enter command

 
Angus Lou
Occasional Advisor

Cannot enter command

I have this 2 core switch model:
HPJ4850A, 5304XL.

Core Switch 1 is linked to Core Switch 2 via
A4 and B4 interface via Fiber Cable.

However, I encounter this error:
Invalid input
15 REPLIES 15
Shadow13
Respected Contributor

Re: Cannot enter command

type admin-edge-port instead of edge-port
that should work
EckerA
Respected Contributor

Re: Cannot enter command

You are saying:
Core Switch 1 is linked to Core Switch 2 via
A4 and B4 interface via Fiber Cable.

does this mean a4 and b4 are members of a trunk? (trk10?)
Shadow13
Respected Contributor

Re: Cannot enter command

Good questuon EcherA i did not notice that :D
Angus Lou
Occasional Advisor

Re: Cannot enter command

Yes, u are right. What are your advise?
Shadow13
Respected Contributor

Re: Cannot enter command

Instead of typing A4 you should type trk10 in the command that you are trying to issue.
Shadow13
Respected Contributor

Re: Cannot enter command

BTW, Points go to EreckA
Shadow13
Respected Contributor

Re: Cannot enter command

Sorry EckerA :D typed it wrong sorry for that
Angus Lou
Occasional Advisor

Re: Cannot enter command

Sorry, I am novice in networking. Why always trk10. iS it defautlt to 10? Can any one elaborate?
Shadow13
Respected Contributor

Re: Cannot enter command

can you post the output of "show run" here


regarding the trk10 this is the name of the aggregated port, you can check the manual for the switch you will find all the description.