- Community Home
- >
- Networking
- >
- Legacy
- >
- Switches, Hubs, Modems
- >
- HP switch 1920 - JG923A - find IP on specific Port
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Forums
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-31-2020 08:40 AM
08-31-2020 08:40 AM
HP switch 1920 - JG923A - find IP on specific Port
Hi,
i have an HP switch 1920-16g JG923A , i would like to know if there is any CLI command to display IP of the connected device on a specific port.
thank you.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-31-2020 08:44 AM
08-31-2020 08:44 AM
Re: HP switch 1920 - JG923A - find IP on specific Port
Hi @grenzo !
If Vlan-interfaces of the switch are default gateways for hosts in respective VLANs, e.g. if you use this switch as a router, then "display arp" should do the job. If you use the switch as L2 switch, I don't think it is possible, simply because in this case it doesn't care about IP addresses.
Hope this helps!
