link aggregation between dell Power connect and hp Procurve

[Vasco Santos]

Hello,

I need some help to do a link aggregation to get a 2G pipe between one dell power connect 6024 layer 3 and a hp procurve 2510-48.

This is the what that i try with port 1 and 2:

on dell:

interface ethernet g1
lacp port-priority 247
lacp timeout long
exit

interface ethernet g2
lacp port-priority 247
lacp timeout long
exit

interface ethernet g2
channel-group 1 mode on
exit

interface ethernet g1
channel-group 1 mode on
exit

interface port-channel 1
description 'LAG'
switchport mode trunk
switchport trunk allowed vlan add 10
no spanning-tree disable
flowcontrol on
exit

on HP:

interface ethernet 1-2
lacp active
exit

trunk 1-2 trk1 lacp
exit


But seams unsuccessful, i also have a vlan 10 that need to go to the trunk.

Can anyone send me in the correct way?
Regards,

VS

[Vasco Santos]

Other info:

#hp

show lacp

LACP

PORT LACP TRUNK PORT LACP LACP
NUMB ENABLED GROUP STATUS PARTNER STATUS
---- ------- ------- ------- ------- -------
1 Active Trk1 Up Yes Success
2 Active Trk1 Up Yes Success

#dell
show lacp port-channel 1
Port-Channel ch1
Port Type Gigabit Ethernet
Attached Lag id:
Actor
System Priority:120
MAC Address: 00:15:c5:2c:51:d3
Admin Key: 25
Oper Key: 25
Partner
System Priority:12736
MAC Address: d4:85:64:e8:31:c0
Oper Key: 49


This seams to be right to me.

But no luck

[Peter Oudakker]

I had the same problem between HP Procurve 1810G-24 and Dell PowerConnect 2716.

Try to make on your HP switch a STATIC LAG! (default on my 1810G it creates an Dynamic trunk)

The only problem I now have is that my internet connection sometimes drops. When I disable the LAG between the HP and Dell, all keeps working fine.

I don't know what the source of this problem is. I need to investigate this also.