Problem with VLAN

[fluk3d]

Hello - Below is my current switch configuration. I have setup a "trunk" between my firewall and port d19 on vlan 60. Whenever I use the IP address of the vlan for vlan60 I am unable to get out to the internet or communicate with the other vlan however if I change the gateway to 192.168.12.1 which is the router in that vlan I can communicate between the default vlan and get out to the internet?

Below is my config

Running configuration:

; J8698A Configuration Editor; Created on release #K.14.34


module 1 type J9307A
module 2 type J9308A
module 3 type J9307A
module 4 type J9308A
module 5 type J9307A
module 6 type J9307A
module 7 type J9307A
module 8 type J9307A
ip default-gateway 192.168.16.1
vlan 1
name "DEFAULT_VLAN"
untagged A1-A24,B1-B24,C1-C24,D1-D19,D21-D24,E1-E24,F1-F24,G1-G24,H1-H24
ip address 192.168.16.48 255.255.255.0
no untagged D20
exit
vlan 50
name "Test"
ip address 192.168.13.2 255.255.255.0
tagged D19
exit
vlan 60
name "Laptops"
untagged D20
ip address 192.168.12.2 255.255.255.0
tagged D19
exit
ip route 0.0.0.0 0.0.0.0 192.168.12.1
spanning-tree

[fluk3d]

Ok - I figured it out I had to enable ip routing on the switch in order for everything to work properly.

[fluk3d]

I enabled ip routing.