HPE GreenLake Administration
- Community Home
- >
- Networking
- >
- Legacy
- >
- Switches, Hubs, Modems
- >
- ROM update mode on Procurve 2524
Switches, Hubs, and Modems
1833767
Members
2054
Online
110063
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Forums
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-12-2007 08:58 PM
03-12-2007 08:58 PM
ROM update mode on Procurve 2524
ho do I update ROM version on Procurve 2524 switch? 'Show system' command shows ROM version 01.01.
Firmware revision : F.05.55
ROM Version : F.01.01
I found command 'update' which Enters ROM update mode, can't find any info about it in documentation. What is it used for?
Firmware revision : F.05.55
ROM Version : F.01.01
I found command 'update' which Enters ROM update mode, can't find any info about it in documentation. What is it used for?
2 REPLIES 2
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-12-2007 09:17 PM
03-12-2007 09:17 PM
Re: ROM update mode on Procurve 2524
With these switches, if a ROM upgrade is required it's automatically done during the firmware update.
The 'update' command reboots the switch into Monitor ROM console (takes the switch offline, serial console access only). You should never need to use this.
The 'update' command reboots the switch into Monitor ROM console (takes the switch offline, serial console access only). You should never need to use this.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-12-2007 09:23 PM
03-12-2007 09:23 PM
Re: ROM update mode on Procurve 2524
I have three 2524 switches and 2 of them have F.02.01.
Is there any difference in operation, if ROM version is different?
Is there any difference in operation, if ROM version is different?
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
Company
Events and news
Customer resources
© Copyright 2025 Hewlett Packard Enterprise Development LP