LAGG on a set of MSR 2004-24 in IRF

[Kiilerich]

Hi

Im testing a set of MSR 2004-24 routers in a IRF setup.

When configurring a Bridge-Aggregation interface across the stack I only get partial success.

LACP is trying to form the connection however then its backing off with the following message:

%Jan  1 02:45:24:411 2011 TestIrf LAGG/6/LAGG_ACTIVE: Member port GE1/0/3 of aggregation group BAGG1 changed to the active state.

%Jan  1 02:45:24:418 2011 TestIrf LAGG/6/LAGG_INACTIVE_HARDWAREVALUE: Member port GE1/0/3 of aggregation group BAGG1 changed to the inactive state, because of the port's hardware restirction.

When configuring the Bridge-Aggregation only across a single physical router anything is working just fine.

I do recall to have read a document somewhere that Bridge-Aggregation was not supported on the MSR2004 across a stack however I cannot find that information anymore.

Anyone know if this is supported or in what document the limitations for the Bridge-Aggregation on the MSR2004 are written?

[Brian_Dsouza]

@Kiilerich You are right.

Please see the document here. The Guide is :

HPE FlexNetwork MSR Router Series Comware 7 Virtual Technologies Configuration Guide, page 10

See attached screenshot stating the same.