- Community Home
- >
- Networking
- >
- Legacy
- >
- Switching and Routing
- >
- Policy Based Routing issue on HP5412
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-04-2011 01:06 PM - edited 10-05-2011 12:23 AM
10-04-2011 01:06 PM - edited 10-05-2011 12:23 AM
Policy Based Routing issue on HP5412
Hello All,
I would like to route a specific IP (or possibly a vlan) via an alternative firewall/gateway/ISP. I believe this can be done by implementing policy based routing on our core switch however I am struggling with the implementation /command syntax
I have added the following configuration to our HP5412zl running K.15.06.0006
route-map "via-entanet-isp" permit seq 10
match ip address prefix-list "via-entanet-isp"
set ip next-hop 10.0.0.13
exit
ip prefix-list "via-entanet-isp" seq 5 permit 10.0.35.128 255.255.255.255 ge 32 le 32
however I can not see any changes to the routing table of the core switch. My question is do I need to apply the policy before I will see any change to the path 10.0.35.128 uses to get to the internet or have I missed something else.
I have attached the running configuration for your perusal
Thanks in advance
Andy