- Community Home
- >
- Networking
- >
- Legacy
- >
- Switching and Routing
- >
- Port address translation on JG732A
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-04-2019 04:21 AM
06-04-2019 04:21 AM
Port address translation on JG732A
Hi, on a Cisco PIX I had a config where the WAN port was 1xx.1x.253.10 and the LAN subnet was 1xx.1xx.68.0/24 - a public IP range.
I had PAT setup so that I could open and close ports for the LAN subnet. By default all incoming ports were closed. If I opened the RDP port then RDP could be used from the WAN to connect to all of the machines on the 68 subnet. Similarly if I opened the SSH port, from the WAN I could SSH to any machine on the 68 subnet.
How do I set this up on a MSR1003-8?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-19-2019 08:16 AM
06-19-2019 08:16 AM
Re: Port address translation on JG732A
Hi,
Please use the below link and follow the guide to configure NAPT (PAT) on MSR1003-8 router.
I am an HPE Employee