- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- WAN Routing
- >
- MSR954 router: How can i build the NAT rules to be...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-20-2017 05:28 AM
12-20-2017 05:28 AM
MSR954 router: How can i build the NAT rules to be dynamic
Hi,
i want to build the NAT rules to be dynamic(i.e. relative to the WAN interface, and not to its specific IP address).
Reason: the WAN interface(s) IP address(es) are dynamic, and may vary everytime the router is switched on (PPP I guess). Especially the LTE WAN interface.
When I create a NAT rule, I select the interface: (I have tried with both “current IPv4” and “Other IPv4”), but the result is the same and is linked to the Global IPv4 specific address, and not to the interface.
I assume i can only setup dynamic through CLI...Can anyone guide me with the correct CLI commands to use to set this up?
Kind regards and thank you in advance,
Nick
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-22-2018 09:46 PM
05-22-2018 09:46 PM
Re: MSR954 router: How can i build the NAT rules to be dynamic
can you provide your detailed config?