HPE Community
WAN Routing
1830470 Members
2642 Online
110005 Solutions
New Discussion

Server Load Balancer 3C16120

 
imanol
New Member

‎09-10-2009 02:20 PM

‎09-10-2009 02:20 PM

Server Load Balancer 3C16120



Configure the load balancer to work, I can not connect to service port 80 from my client

0 Kudos
2 REPLIES 2
ideopathic
New Member

‎09-10-2009 02:45 PM

‎09-10-2009 02:45 PM

Re: Server Load Balancer 3C16120

You will probably need to set up your static routes, with ACL's to control

the IP of inbound traffic. Outbound traffic can then be routed out via load

balancing.
0 Kudos
imanol
New Member

‎09-10-2009 03:03 PM

‎09-10-2009 03:03 PM

Re: Server Load Balancer 3C16120

I don't recieve any response from the virtual IP (VIP) of the load balancer. If I made a ping from the host network I only recieve a response from the IP of the load balancer and from the NAT IP but anything from the VIP. And obviously I don't recieve any response if I try to access my web application using the VIP and the port 80.

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.