Fully disabled web interface, is it possible?

[at-]

Hi there,

I've bought a new HP 1910-24G Switch (JE006A). And do some config, but I've try to completely disabled web interface login, like my config below :

[MCM Distribution Switch-luser-dionipe]service-type telnet
[MCM Distribution Switch-luser-dionipe]save
The current configuration will be written to the device. Are you sure? [Y/N]:y
Please input the file name(*.cfg)[flash:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
flash:/startup.cfg exists, overwrite? [Y/N]:y
 Validating file. Please wait....
 Saved the current configuration to mainboard device successfully.
 Configuration is saved to device successfully.
[MCM Distribution Switch-luser-dionipe]display local-user service-type telnet
The contents of local user admin:
 State:                    Active
 ServiceType:              telnet/terminal/web
 Access-limit:             Disabled          Current AccessNum: 0
 User-group:               system
 Bind attributes:
 Authorization attributes:
  User Privilege:          3
The contents of local user at:
 State:                    Active
 ServiceType:              telnet/terminal/web
 Access-limit:             Disabled          Current AccessNum: 1
 User-group:               system
 Bind attributes:
 Authorization attributes:
  User Privilege:          3
The contents of local user dionipe:
 State:                    Active
 ServiceType:              telnet/terminal/web
 Access-limit:             Disabled          Current AccessNum: 0
 User-group:               system
 Bind attributes:
 Authorization attributes:
  User Privilege:          3
Total 3 local user(s) matched.

Is there any way to completely disable web interface? :)

Regards,

Dewangga

P.S. This thread has been moved from Switching > Comware-Based to Web and Unmanaged - Hp Forum moderator

[at-]

It's funny, I discover my problem by my self. LOL! I must be disable http service first before I changes user service-type :) And I should disabled it via web based, can't be done from console. Console only has option to enable it, not to disable.

Solved :)