Jumbo frame 1920s

[yfourar]

Hello everybody, 

I have an HPE switch 1920s, I would like to enable the Jumbo frame feature, but I can't find a way to do that,

but I found something in the (switching-edit port configuration) part a way to increase the MTU from 1500 to 9000, so the question that arises here is is it the same thing ? & if I do that,Does it consider as if I enable the jumbo frame?

 http://image.noelshack.com/fichiers/2021/33/3/1629276807-mtu.png 

Thank you.

[akg7]

Hello @yfourar ,

I believe this is only way to increase frame size since there is no cli option available in Aruab 1920s switch.

Refer below user guide:

https://support.hpe.com/hpesc/public/docDisplay?docId=a00003478en_us

And if you  changing value for trunk (LAG) port then no need to change into physical interfaces, just change frame size into trunk (trk1).

Thanks!

[Ihaqueit]

1. I would assume Jumbo frames are on by default on these "semi-intelligent" switches.

2. If you have anything that will actually benefit from using jumbo frames, you would probably have much more advanced switches.