Posted to: ProLiant Servers (ML,DL,SL)
Tuesday I've got a DL320e Gen8 with (4) 6tb hdds that I provisioned as Raid 1+0 (1 logical drive) in Intelligent Provisiong.During the Server 2022 installation, I selected my 1 Unallocated partion and carved out a 64gb piece as my OS partition (Drive 1). It... Posted to: Operating System - HP-UX
Tuesday hello i am an active duty sailor with the united states navy and i am having an issue with a computer upon initial boot up. some background informaton i am not an IT or super computer savy but have been given the task to learn about this console and ... Posted to: ProLiant Servers (ML,DL,SL)
Tuesday Is it possible to convert RAID 1 to RAID 5 without loosing data,OS, and partition on RAID 1 drives while converting to RAID5 ? Posted to: StoreEver Tape Storage
a week ago My HP Ultrium 3000 external tape drive is not being detected by the computer at all. I've tried everything I could find with regard to installing drivers, checking compatibility, etc, but to no avail.Symptoms:* The tape drive powers up correctly, and... Posted to: MSA Storage
a week ago Good Day,I am trying to setup a SAN storage for 7 servers with each server attached storage been 92TB with capability for Snapshot etc Can this be done with HPMSA 2060. Please help advise the best way to go about this. Appreciate Posted to: ProLiant Servers (ML,DL,SL)
a week ago HiToday we had sudden power outage and after our server poweres on the health led started blinking in amber. I went to ilo 5 page and noticed that storage is degraded. I went further and in front of storage enclosure was not available. All other comp... Posted to: ProLiant Servers (ML,DL,SL)
a week ago Hello. Physical disks are not displayed in ilo. The question when adding a disk to the server is how to add it to the array and monitor the status of the disks.Server ProLiant DL380p Gen8 Posted to: ProLiant Servers (ML,DL,SL)
2 weeks ago Hi Team, I get these below errors while using the DL360 gen 9 10gig nic's"[ 487.089476] vfio-pci 0000:05:00.0: Firmware has requested this device have a 1:1 IOMMU mapping, rejecting configuring the device without a 1:1 mapping. Contact your platform ... Posted to: ProLiant Servers (ML,DL,SL)
2 weeks ago I just installed an Alma Linux-8, on an HPE PROLIANT ML-110 Gen 11 server. I have updated all the drivers from the official website but the fan continues to work constantly at 100% and it is impossible to work with so much noise. Any ideas? Any way t... Posted to: Servers - General
2 weeks ago Is there a powershell command that will allow me to see both the server serial number and the disk serial number at the same time on the hp dl380 Gen10-11 server? It seems very difficult to do this one by one from the ilo interface on about 950 serve...
