HPE Community
BladeSystem - General
1821855 Members
3684 Online
109638 Solutions
New Discussion юеВ

1/10GB VC_ENET module replacement

 
Twister
Occasional Advisor

тАО08-14-2008 08:37 AM

тАО08-14-2008 08:37 AM

1/10GB VC_ENET module replacement

I tried to swap out a defective module but the replacement would not get a configuration from VC Mngr.

Is there any steps I should take to replace this module. I was replacing the standby module in slot 2?

Thanks
0 Kudos
Reply
2 REPLIES 2
WFHC-WI
Honored Contributor

тАО08-14-2008 03:25 PM

тАО08-14-2008 03:25 PM

Re: 1/10GB VC_ENET module replacement

I found this once but after failing over the OA to the standby and then failing back over the problem resolved itself.
0 Kudos
Reply
JKytsi
Honored Contributor

тАО08-15-2008 03:01 AM

тАО08-15-2008 03:01 AM

Re: 1/10GB VC_ENET module replacement

Check the firmware level on replacement module. Both modules should have same version and it should be supported by the OA firmware.
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.