"Corrected threshold exceeded" Memory Error on BL460c

[Fabietto]

Why the following error: Corrected Memory Error threshold exceeded (System Memory, Memory Module 5) countinuously appears even if all memory DIMMS have been replaced??

Thanks a lot,
Fabio

[JKytsi]

could be a faulty mainboard or a BIOS update needed.

[JKytsi]

And what is your Proliant support pack version ?

[Fabietto]

ProLiant support Pack version 8

[JKytsi]

hmm ... and you have Advanced ECC enabled in BIOS (default setting)

[Quality Center: Connect]

Are there any updates to this thread?

We are experiencing the same issue on multiple BL460c servers (10% of the blades). We have switched out the DIMMs but with the same "Corrected Memory Error threshold exceeded (System Memory, Memory Module x)".

We have performed blade firmware updates (L15 11/02/2008) which has alleviated our reboot issues but not the RAM error.

Thank you for any help.

[Timur S Lukovkin]

Have you checked this advisory?

http://h10025.www1.hp.com/ewfrf/wc/document?docname=c01591101&cc=us&dlc=en&lc=en&jumpid=reg_R1002_USEN

regards.